Home Page  Fly Tying Courses & Tuition  Flies  On Line Sales

Guided Fly Fishing  Articles  Contacts 

NYMPHS & WETS

FUZZY NYMPH

If your only going to carry one nymph pattern this is the one. Whilst this nymph is not tied to represent the nymphal (sub imago or pupa) stage of any specific insect it is a good “buggy” looking fly and readily accepted by trout. Tie it in black, brown, dark olive as well as "Red Tag" and  “Adams” or  “Hare & Copper” colours and carry a larger (size #10) and smaller (size #14) version of each.

MATERIALS:

Hook - Size 10  & 14 long shank
Thread  - To suit body
Tail  - Feather fibres
Rib   Fine copper wire
Weight  - Lead wire if required
Body, thorax & legs  - Dubbing
Wing casing  - Rubber shrimp back


A)
  1. Wind the thread in touching turns to the bend of the hook.
  2. Tie in a tail equal 1/2 to 2/3 the length of the hook shank. Resist the temptation to make the tail too bulky and too long.                                                   
 

   3.  Tie in a length of copper wire.

  1. If you going to add weight to the fly now is the time to do it. One of the easiest ways is to use lead wire. Wind the lead wire around the hook shank placing it as far forward as possible. This will enhance the swimming action of the fly.
  2. Wind the thread forward and then back over the lead to secure it in position. You can also add a drop of head varnish if you like.
  3. There are of course other ways of adding weight to a fly.

 

 

 

 

 



B)
  1. Dub on a body starting at almost nothing and gradually increasing in width along the back half of the fly.

  2. Wind the copper wire along the body of the fly forming 5 or 6 segments.

  3. Tie the copper wire off at the half way point and trim the excess copper wire.




C)
  1. Tie in the back material directly in front of the body and the gills.




D)
  1. Hold the back material out of the way and dub on the thorax making it about 50% thicker than the thickest part of the body.
  2. Pull the back material over the top of the fly and whilst holding it tight and in place tie it off just behind the eye of the hook.
  3. Trim the excess back material whip finish and varnish the thread.

 



E)
  1. Using a piece of male Velcro as shown in the previous image tease out the dubbing fibres to represent the legs of the fly.

 



Copyright © 2005 Stephen Chatterton / Fish on Fly P/L - All rights reserved.
Last modified:10-Jun-2008.

 

Back To Top